Specifications
Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.4.2 Release Notes
88
PD4-616376481,
PD4-901339862
The following error message is displayed during NetloginMac_V2 regression after rebooting
a switch with the save option set to yes:
<Erro:HAL.Card.Error> MSM-A: Unable to remove broadcast MAC entry
for VLAN/VMAN while changing tag from 1 to 3999
PD4-1079033931,
PD4-751999119
When configuring HQoS, traffic goes to the correct traffic queue but is not limited by the
meter threshold rate.
PD4-735984501 DUT crashes while configuring static routes via 6in4 tunnels.
PD4-856182552,
PD4-698686480
Even after a vMAN ethertype is changed using the CLI, packets are egressing out the
service vMAN using an older vMAN ethertype.
PD4-882862525,
PD4-723664780
After performing a hitless upgrade from ExtremeXOS 12.0 or later to ExtremeXOS 12.1 or
later, packets are sent to the CPU for L3 switching, even though hardware entries exist
for the destination IP.
PD4-828265583,
PD4-569838439
Packets that need to be L2 switched are not egressing if the packets hit the IPv4 ACL
containing a redirect action.
This fix requires a regular upgrade on a BlackDiamond 12804 switch. It will not work if
you attempt a hitless upgrade on the BlackDiamond 12804 switch.
PD4-882862632,
PD4-852419857
Creating and deleting HQoS queues on a BlackDiamond 12808 results in the following
error:
Error: Timeout awaiting Traffic Queue operation.
PD4-973716520,
PD4-964896284
When PIM Sparse mode is configured on a BlackDiamond 8800 series switch with c-
series I/O modules, a memory leak is detected.
PD4-979176325,
PD4-832095668
The ACL match condition ports ingress <port-no> causes incoming packets to be
forwarded to all ports in a VLAN as per the VLAN tag for incoming packets, even though
the ingress port is not part of that VLAN.
BlackDiamond 20800 Series Switch
PD4-913402141,
PD4-1034364517
Process XMLD crashes if multiple "OpenSession" XML requests are sent continuously.
PD4-728449478 The ucRx: micro controller returns the following error message while running diagnostics:
reset hello error Unrecognized command: hello
feConfig = fffe2848
PD4-551040931 Multicast traffic is dropped after disabling load-share port links using MVR.
PD4-927699591 Running an ExtremeXOS 12.3 image in the Delay Measurement Message (DMM)
originator, and a later version of ExtremeXOS on a BlackDiamond 20808 on the other
end, Y.1731 does not work. The Delay Measurement Reply (DMR) is received by the
originator, but rejected due to an incorrect check in the application.
PD4-978540087,
PD4-978263097
During a malfunction of an adjacent node, excessive DHCP traffic is flooded to the switch
causing watchdog failures and outages.
PD4-749215601 Running the install firmware command generates the following error message:
reading from file /dev/mtd0 failed: Cannot allocate memory
.FAILED: SLOT 18, MM PMON
UPGRADE NOT REQUIRED: SLOT 18, MM Spanky Primary
Error:can't read "pfc": no such variable
PD4-1077149606 A DUT displays errors when a policy file is configured with traffic queues on a VLAN or
vMAN.
PD4-1056438821 If a meter is attached to an egress traffic queue after an ingress traffic queue and an
egress traffic queue association, the meter does not take effect.
Workaround: Configure the aggregate meter for the egress traffic queue first and then
associate it with an ingress traffic queue.
Table 44: Platform-Specific and Feature PDs (Continued)
PD Number Description