Specifications

Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.4.2 Release Notes
71
QoS
PD3-67431351 Configuring an ingress traffic queue and an egress traffic queue association to multiple
ports in sequential order generates the following error:
Egress queue already associated to this ingress queue
Configuration failed on backup MSM, command execution aborted!
PD3-16578296 The member ports of a trunk will retain the QoS profile configuration of the trunk (based
on the master port) after load sharing is disabled, or if a port is removed from the trunk.
RMON
PD3-12950492 Issuing the clear counter command might cause a high number to be displayed in
variables such as etherHistoryOctets, etherHistoryPkts, and etherHistoryTable.
ScreenPlay
PD3-111344472 ScreenPlay allows you to configure DHCP but you cannot enable DHCP.
Security
PD3-205012219 The source-ip-lockdown dynamic deny acl counter is not working properly and increments
valid traffic from a trusted client.
PD3-186939931 Ingress mirroring is not working for DHCP snooping when snooping is enabled on
BlackDiamond 12800 series switches. DHCP snooping works correctly when DHCP
snooping is disabled.
PD3-75120608 The unconfigure radius and unconfigure tacacs commands do not reset the
timeout value to the system default of 3 seconds.
SNMP
PD4-705730556 AES/3des users created using ExtremeXOS 12.3.1 software cannot be used for SNMP
operations in ExtremeXOS 12.1 or earlier releases. This may cause the SNMP master to
crash.
Spanning Tree Protocol
PD3-189927343 A temporary loop occurs when a root bridge is taken down by disabling all ports or
powering down the switch.
WAN PHY
PD3-101226461 When show wan-phy commands are run on non WAN PHY ports, the ports display the
headers. It should only display the error wan command is not supported on
non-wanphy port 25.
Table 39: Platform-Specific and Feature PDs (Continued)
PD Number Description