Specifications

Upgrading the BootROM
ExtremeWare XOS 11.0 Concepts Guide 319
The following describes some ways that you can use the Bootloader.
• Viewing images—To display a list of installed images, use the show image command.
• Selecting an image—To change the image that the switch boots from in flash memory, use the boot
{image number}
command. If you specify image number, the specified image is booted. If you do
not specify an image name, the default image is booted.
• Selecting a configuration—To select a different configuration from the one currently running, use the
config {default | file <filename> | none} command. This command is useful if you
experience a problem with the current configuration and there is an alternate configuration available.
— file—Specifies a configuration file name
— default—Specifies the default configuration file
— none—Uses no configuration
To view the current configuration, use this command without any arguments.
To exit the Bootloader, use the boot command. Specifying boot runs the currently selected ExtremeWare
XOS image.
Upgrading the BootROM
Upgrade the BootROM using TFTP (from the CLI), after the switch has booted. Upgrade the BootROM
only when asked to do so by an Extreme Networks technical representative. To upgrade the BootROM,
use the following command:
download bootrom [[<ipaddress> | <hostname>] <filename> {{vr} <vrname>}] | memorycard
<filename>]