Specifications

746 ExtremeWare XOS 10.1 Command Reference Guide
Troubleshooting Commands
NOTE
To access the Bootloader, you can depress any key until the applications load and run on the switch.
As soon as you see the BOOTLOADER-> prompt, release the key. From here, you can run the
diagnostics on the MSM.
To run diagnostics on the MSM, follow these steps:
1 Identify the images currently running by using the show images command.
2 Run diagnostics on the MSM by using the following command:
boot [1-4]
The numbers 1 through 4 correlate to specific images and diagnostics on the MSM:
• 1—XOS primary image
• 2—XOS secondary image
• 3—Diagnostics for image 1 (initiates diagnostics for the primary image)
• 4—Diagnostics for image 2 (initiates diagnostics for the secondary image)
For example, to run diagnostics on the primary image, use the following command:
boot 3
When the test is finished, the MSM reboots and runs XOS.
Viewing Diagnostics. To view results of the last diagnostics test run, use the following command:
show diagnostics [msm-a | msm-b | slot <slot>]
If the results indicate that the diagnostic failed, replace the module with another module of the same
type.
Example
The following command runs extended diagnostics on the module in slot 3 of a BlackDiamond 10808
chassis:
run diagnostics extended slot 3