Specifications

download image
ExtremeWare XOS 10.1 Command Reference Guide 729
Before the download begins, you are asked if you want to install the image immediately after the
download is finished. If you install the image immediately after download, you must reboot the switch.
Enter
y to install the image after download. Enter n to install the image at a later time.
If you download and install the software image on the active partition, you need to reboot the switch.
The following message appears when downloading and installing on the active partition:
Image will be installed to the active partition, a reboot required. Do you want to
continue? (y or n)
Enter y to continue the installation and reboot the switch. Enter n to cancel.
If you install the image at a later time, use the following command to install the software:
install image <fname> {reboot}
Where fname specifies the filename of the new, downloaded image.
Example
The following command downloads the switch software image from the TFTP server named tftphost,
from the file named bd10k-10.1.0.89.tgz:
download image tftphost bd10k-10.1.0.89.tgz
If you download the image into the active partition, you will see output similar to the following:
M1.2 # download image tftphost bd10k-10.1.0.89.tgz
Do you want to install image after downloading ? (y or n) Yes
......................................................................................
........
Image will be installed to the active partition, a reboot required. Do you want to
continue ? (y or n) Yes
Installing to primary partition!
......................................................................................
......................................................................................
.........
If you answer yes to installing the image, the switch reboots upon completion of the installation.