Specifications

Issues Resolved in ExtremeWare 7.0.0b68
ExtremeWare 7.0 Release Notes 61
If you configure more than 10 ATM PVCs on a switch and upload the configuration, the switch no
longer crashes (PD2-120100801).
Summit
If you download a configuration, autopolarity detection is no longer automatically enabled on the
Summit48si (PD2-118279201).
The
configure ports auto-polarity command is no longer available on platforms other than the
Summit48si (PD2-118503001).
Issues Resolved in ExtremeWare 7.0.0b68
The following issues were resolved in ExtremeWare 7.0.0b68. Numbers in parentheses are for internal
use and can be ignored.
BlackDiamond
On the BlackDiamond 6816, the syslog no longer reports memory mapping failures on the MSM64i in
slot B as being on the MSM64i in slot C (PD2-112505701).
Alpine
When using T1 modules, if all ports are tagged in the same VLAN and traffic stops completely, the T1
FDB entries now age out correctly (PD2-117286601).
ESRP
You can no longer configure a failover priority greater than the upper limit, which is 255. Values greater
than 255 generate error messages (PD2-97286301).
You can no longer configure the ESRP tracking failover priority to a value greater than or equal to the
ESRP VLAN priority (PD2-81790880).
You are no longer required to disable load sharing before adding or deleting ESRP restart ports that are
also in the load sharing group (PD2-110113235).
The
show esrp command output now contains VLANs with both IPX and IP enabled (PD2-102292601).
You are no longer able to create more than 64 ESRP domains (PD2-97286303).
Spanning Tree
After an STP recovery, an IGMP snooping disabled VLAN now correctly forwards multicast streams.
(PD2-109828901).
QoS
The ACL FDB is now completely cleared when you delete flow redirect rules (1-EQRVD,
PD2-110802201).