Specifications

ExtremeWare 7.0 Release Notes 5
System Health Check Events Might Not Be Logged 39
Configuring Two Multilink groups on One T1 or E1 Module 39
Limited Commands Mode 39
T1 and E1 Error Message 39
VDSL Modules in a Half-Duplex Link 39
Summit 40
Health Check Error Messages 40
Limited Commands Mode 40
Summit48i Redundant PHY 40
Summit48i Single Fiber Signal Loss 40
SNMP Results for Power Sources 40
Summit48si MIB value for Input Power Voltage 40
Command Line Interface (CLI) 40
Only US Character Set Supported 40
The show iproute Command 40
Serial and Telnet Configuration 41
Displaying Management Port with show port config 41
Auto Negotiation and 1000BaseT Ports 41
Switching and VLANs 41
Saving ip-mtu Settings 41
FDB 41
Configure Less Than 400 Ports in a VLAN 41
Cannot Delete “mgmt-1” VLAN 41
VLAN priority and STP, EDP 41
Default Routes or Static Routes 42
Configuring a Protocol Filter with ‘ffff’ 42
Deleting Protocols from a VLAN 42
MAC Based VLANs and DHCP Relay 42
VLAN to VLAN Access Profiles 42
Load Sharing 42
Spanning Tree 43
MAC Security 43
Mirroring 44
QoS 44
The qosprofile Accepts a Value Greater than 100% 44
Re-Ordering Access List Precedence Numbers 44
Access List FDB Entries not Cleaned Up 44
Access Lists Using the IP Deny Any Rule 44
Access Lists and IP Fragmentation 44
QoS Configuration Bandwidth Parameters 44
Access List Precedence Intervals 45
Creating Access Lists from Multiple Sessions 45
QoS and dot1p 45
5,120 Access Lists and SNMP 45
Monitoring QoS and the show port qos Command 45
Ingress QoS 45
Ingress QoS Not Supported on Other Modules 45
The show ports ingress stats Command Truncates 45
Bi-Directional Rate Shaping 46