Specifications

Clarifications and Known Behaviors
ExtremeWare 7.0 Release Notes 35
Routing Traffic Through the MGMT Port
Routing entries with a next hop in the management interface subnet are not removed from the routing
table based on the MGMT port state (PD2-104430127).
Configuring the Timezone
After configuring the timezone, a soft reboot can cause the switch to boot into minimum mode
(PD2-109830723).
Blank Space in show port info detail Command Output
The output of the show port info detail command contains several blank pages. The output still
contains all of the requested information (PD2-107800978).
Using an ExtremeWare 7.0 Configuration with an Earlier Image
If you are using an ExtremeWare 7.0 configuration and attempt to use an earlier image, the switch
prompts you for confirmation (because this combination is not recommended). If you answer
n at the
prompt, you receive the following error message:
Error: bad image.
You can safely ignore this message (PD2-110983501).
Console Response with a Large Number of ARP Entries
Console reponse is slow when the switch is learning 10,000 or more ARP entries. This does not affect
performance. Console response returns to normal when the entries are learned (PD2-104103941).
Configuring 1000Base-T Ports for 10,000 Mbps
The switch erroneously allows you to configure a 1000Base-T port to 10,000 Mbps. 1000Base-T ports do
not support 10,000 Mbps (PD2-108463706).
The show log chronological Command
When the syslog contains more than 1,000 lines, the show log chronological command displays
nothing. However, the command
show log displays correctly (PD2-104062736).
BOOTP-Dependent Routes in Downloaded Configuration not Created
Static and default routes that depend on a BOOTP IP address/subnet are not created when you
download a configuration (PD2-86888351).
Enable Flow Statistics Ping-Checking
Flow statistics requires ping-checking to ensure that the flow-collectors are operating. Flow statistics
ping-checking is disabled by default. You must enable flow statistics ping-checking to enable flow
statistics (PD2-110325062).