Specifications

Upgrading ExtremeWare
ExtremeWare 7.0 Release Notes 25
Upgrade ATM, MPLS, ARM, PoS, T1, E1, or T3 Modules
If you are using a ATM, MPLS, ARM, PoS, T1, E1, or T3 module, upgrade the module to ExtremeWare
7.0.1:
1 TFTP download the latest ExtremeWare version for the module using the
download image slot
command.
NOTE
T1, E1, and T3 modules must be using ExtremeWare 6.1.8b79 before upgrading to ExtremeWare
7.0.1.
2 Reboot the module using the
reboot slot command.
NOTE
If you are upgrading multiple modules, skip step 2 until you have upgraded every module, then
reboot the switch.
3 Download the BootROM using the
download bootrom slot command.
4 Reboot the module using the
reboot slot command.
NOTE
If you are upgrading multiple modules, skip step 4, upgrade every module, then reboot the switch.
Upgrading an Alpine 3802 to ExtremeWare 7.0.1
To upgrade an Alpine 3802 to ExtremeWare 7.0.1:
1 Upload the configuration to your TFTP server using the
upload configuration command.
2 Upgrade to BootROM 7.8 using the
download bootrom command.
3 Reboot the switch using the
reboot command.
4 TFTP download ExtremeWare 6.1.8w3.0.1 b79 to the primary image space using the
download image
primary
command.
5 Verify that the correct BootROM and ExtremeWare versions are loaded on the switch using the
show
switch
and show version commands.
6 Clear your switch using the
unconfigure switch all command (this is required by the beta
software).
7 Answer
y at the prompt to reboot the switch.
8 TFTP download ExtremeWare 7.0.0b46 to the primary image space using the
download image
primary
command.
9 Reboot the switch using the
reboot command.
10 TFTP download the latest ExtremeWare 7.0.1 build to the primary image space using the
download
image primary
command.
11 Reboot the switch using the
reboot command.
12 TFTP download the configuration you saved in Step 1, and enter
y to reboot the switch.
13 Check the log for configuration errors. Manually enter configurations that did not load.