User guide

8-44 EXTREMEWARE ENTERPRISE MANAGER INSTALLATION AND USER GUIDE
USING THE POLICY SYSTEM
QoS treatments cannot be added or deleted. You can change the names and descriptions
of all five treatments, and you can change the priority and bandwidths of the four
quality treatments.
Treatments can be scoped, so that you can have different treatment parameters for each
device group.
• To change the scope for the treatments, click All Device Groups or Selected Device
Groups. If the treatment is to be scoped for specific device groups, you can select
those groups from the pull-down list in the Selected Device Group field, or type the
Device Group names into the field (separated by semi-colons).
• To change the minimum bandwidth for the treatment, type a value into the
Minimum Bandwidth field. The value must be between 0 and 90, and less than or
equal to the value you plan to use for maximum bandwidth.
Note:
The sum of all minimum bandwidth cannot be greater than 90%.
• To change the maximum bandwidth for the treatment, type a value into the
Maximum Bandwidth field. The value must be between 0 and 100, and greater than
or equal to the minimum bandwidth specified in the previous field.
• To change the priority, select a priority (Low, Normal, Medium, or High) from the
pull-down list in the Priority field.
ADDING OR MODIFYING LOCAL USERS
1 To add a new user, click New at the top of the Policy System page, then select User
from the pull-down list.
To modify an existing End Station, select Local Users under the Users entry in the
Component Tree.
Either method will display the Network User page as shown in Figure 8-23.