User guide

2-8 ExtremeWare EPICenter Software User Guide
Installing the EPICenter Software
activation key to obtain a permanent license key from the Extreme Networks web site
at
http://www.extremenetworks.com/go/epickey.htm
See Chapter 1 of this manual or the ExtremeWare EPICenter SE Release Note and Quick
Start Guide for details on obtaining an evaluation or permanent license key.
If you have purchased the EPICenter software and an additional module such as the
Policy Manager, you can use the key you received for the optional module here. It will
enable both the EPICenter software and the additional module.
If you do not yet have a key, you canstill install the product, and then update the key
later using the
instlic.exe utility. See “Adding or Updating the License Key” on
page 2-10.
— To skip entering a key, leave the field blank and click Next.
— A warning box pops up; click OK to continue.
9 In the Destination dialog box, choose one of two options:
— Accept the default target drive and folder displayed in the Destination Directory
box.
— Click Browse and select or enter a new folder, a new drive, or both.
If you are installing on a disk that uses the FAT file system rather than the NTFS file
system, a warning message pops up when you click Next.Thisisbecauseunderthe
FAT file system, the EPICenter software can take up as much as 20% of your partition,
regardless of the size of the partition.
10 Accept the default program folder, EPICenter 3.1, or enter a different program folder
name, and click Next.
11 IntheDatabaseServerInformationdialogbox,enteranumberintothePort fieldforthe
TCP port that the EPICenter Web Server willuse to communicate with thedatabase, or
accept the default (2638). You can use any port number (a number between 1024 and
9999 is recommended) except a port number already in use by another process.
12 In the Get HTTP Port dialog box, you are asked for two ports that the EPICenter Web
Server will use:
— The HTTP Port for communication with clients (default 80).
— The Admin Port used by the EPICenter web server (default 8007).
Accept any or all of the default port numbers, or enter different port numbers.
You can use any port number (a number between 1024 and 9999 is recommended)
except:
— The port number you just entered for the database TCP port.
— Any port number already in use by anotherprocess.