User guide

16-16 ExtremeWare EPICenter Software Installation and User Guide
Dynamic Reports
The list of ports is sorted initially by IP address. Click the heading of a column to sort the
report based on the contents of that column. For example, to sort by operational status,
click on the OperStatus heading.
You can filter the ports that are displayed by constructing a conditional filter using the
fields at the bottom of the page. This lets you construct a two-clause filter statement in the
form shown in Figure 16-4.
Figure 16-4: Device Ports filter specification
You can filter on any of the variables shown in the report.
Resource to Attribute Mapping Report
The Resource to Attribute Mapping Report displays a list of all the resources that include
the specified attribute. Click the Resource to Attribute Mapping link in the left-hand
panel to display the attribute selection field. Then select an attribute from the pull-down
list, as shown in Figure 16-5.
Figure 16-5: Attribute specification for Resource to Attribute Mapping report