User guide

ExtremeWare EPICenter Software Installation and User Guide 14-5
Viewing ESRP Detail Information
The Detailed ESRP Information view displays the following information:
• Switch Name:Thenameof the switch, if known.(If theswitchisnot beingmanagedby
EPICenter, this field will contain “N/A”)
•MAC: The MAC address of this switch
• State: The current state of the switch—Masteror Slave
•Priority: A user-defined value, between 0 and 254, which can be used by the ESRP
election algorithm in determining which switch is the Master switch. The default is 0
•ToMaster: The number of times this switch has transitioned to become a Master
• ToSlave: The number of times this switch has transitioned to become a Slave
The number of Master and Slave transitions cannot be obtained from versions
of ExtremeWare prior to version 6.1.6. For switches running earlier versions of
ExtremeWare, the display defaults to “N/A.”
If some of the ESRP-enabled switches in an ESRP-enabled VLAN are not
managed by EPICenter, the ToMaster and ToSlave values for those switches
will not be updated until the next ESRP polling interval.
• Active Ports: The number of active ports in this ESRP-enable VLAN
• TrackedActivePorts: The number of tracked ports that are currently active
• TrackedIPRoutes: The number of tracked IP routes that are currently active
• TrackedPings: The number of tracked ping responders that are responding
successfully.
The number of Tracked Pings cannot be obtained from versions of
ExtremeWare prior to version 6.1.6. For switches running earlier versions of
ExtremeWare, the display defaults to zero.