User guide

ExtremeWare EPICenter Software Installation and User Guide 13-13
Adding and Deleting Protocol Filters
12 Change the IP address and IP mask as appropriate. Click the Enable IP forwarding
check box to enable or disable IP forwarding for this VLAN on the switch.
13 Click Apply to implement the changes.
14 Click Close to exit the window.
Adding and Deleting Protocol Filters
Users with Administrator or Manager access can view, add, and delete protocol filter
definitions. If you have Monitor access, you can view filter definitions,but notadd or
delete them.
To view, delete, or add protocol filter definitions, do the following:
1 Click Protocol Filters in the VLAN Manager.
The View/Delete page of the Protocol Panel dialog box is displayed, as shown in
Figure 13-10.
.
Figure 13-10: Protocol Panel dialog box, View/Delete page
This pageshows all the protocol filters configured within the EPICenter database. Any
filters that are in use by a VLAN are indicated with an asterisk (*) inthe In Use column.
2 To delete a protocol filter, select a filter in the list, and click Delete.
This deletes the protocol filter from all Extreme Networks switches managed by the
EPICenter software, as well as from the EPICenter database.