User guide

13-8 ExtremeWare EPICenter Software Installation and User Guide
Using the VLAN Manager
6 Select one or more ports from the Available Ports list.
7 Click Tagged to add the port as a tagged port. Click Untagged to add the port as an
untagged port.
If this is an untagged VLAN, you are not able to add a tagged port.
When you add an untagged port to a VLAN, it is automatically removed from any
other VLAN which uses the same protocol as the new VLAN, and where the portis an
untagged member.
You canadd aswitch to a VLAN as a unit—just select the switch withoutselecting any
ports, and click Tagged or Untagged to add the switch to the VLAN.
8 To remove a port from the VLAN, select the port from the Ports in VLAN list, and then
click Remove.
9 When you have finished adding ports to the VLAN, click Apply to implement the
changes.
TheVLANiscreatedontheswitcheswhoseportsaremembersofthenewVLAN.
Once you have added a VLAN, you can specify an IP address and mask for the VLAN on
each switch, and also enable or disable IP Forwarding.
1 Select the IP Forwarding tab at the top of the Add VLAN window.
The IP Forwarding page is displayed, as shown in Figure 13-6.