User guide

12-14 ExtremeWare EPICenter Software Installation and User Guide
Network Topology Views
• Click the “Create new map link” icon on the icon bar
A link is added to your map, as shown in Figure 12-10.
Figure 12-10: Adding a link to your map
To attach the link between two map nodes, follow these steps:
1 Select one of the red triangles, then wait until a move cursor appears
2 Drag and drop one end of the link onto one of the node you want to connect
3 Do the same with the other end of the link
After the link is connected, you can specifyendpoint forthe link.To specifythe end points,
follow these steps:
1 Select the link
2 In the right-hand information panel, select the portfor the endpoint from the list in the
Port field for first device
3 Select the port for the other endpoint from the list in the Port fieldforseconddevice,as
shown in Figure 12-11