User guide

6-10 ExtremeWare EPICenter Software Installation and User Guide
Configuration Manager
The EPICenter software does not save the configuration on the device after the reboot.
You can use the Telnet applet to open a telnet session on the affected devices and
execute a save configuration command.
Downloading an Incremental Configuration to
Devices
You can create ordesignate a set of configuration information to be used as a baseline
configuration for devices running ExtremeWare 6.0 or later. Using an incremental
downloadto execute abaseline configuration provides aknown,“standard”configuration
that you can use to ensure that devices are configured into a known state. For example, if
you want to set a group of devices to the same basic configuration, you can first set
individual IP addresses on each device, and thenuse the incremental configuration
download feature to set all other configuration settings on all devices to a common state.
An incremental configuration download executes only the commands specified in the
incremental download file. It does not reset the switch configuration or replace any other
configuration settings that may exist in the device. No reboot is necessary. The EPICenter
incremental download does not save the configuration; you must do so
Incremental downloads are supported on Extreme Networks devices running
ExtremeWare 6.0 or later.
To download an incremental configuration to a device, click the Incremental button atthe
top of the window.
The Download Incremental Config To Devices window appears, as shown in Figure 6-6.