User guide

ExtremeWare EPICenter Software Installation and User Guide 5-15
Defining Alarms
ports.You couldalso define a port group for the specific ports ofinterest, the scope the
alarm as Port Group and select the appropriate group.
• Select Group: If you selectDeviceorPort as theSource Type, you must selecta Device
Group to indicate what set of devices (and ports) you want to see in the Source List.
• Source list (Device/DeviceGroup/Port Group): Thelistof components ofthespecified
type. The field label changes based on the Source Type. It is labeled Device when you
select either Device or Port as the Source Type.
• ifIndex: The listof ports available on the device selected inthe Devices Sourcelist.This
list appears only if you have selected Port as the Source Type. Select a device from the
Device list, and the appropriate set of ports forthe device appears.
• Selection: Thedevices,ports,devicegroups,orportgroupsthatarecurrentlyincluded
in the scope.
•Add->:Adds the selected Device(s), Port(s), Device Groups or Port Groups to the
Selections list, for inclusion in the scope of this alarm.
• Add All->: Adds all the components in the Source list to the Selection list.
• <-Remove: Removes the selected components from the Selection list.
• <-Remove All: Removes all the components from the Selection list.
The Alarm Actions
To define actions for the alarm, click the Actions tab. The Action definition page is
displayed, as shown in Figure 5-7.