User guide
E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
4-5
B
LACK
D
IAMOND
AND
A
LPINE
S
WITCH
P
ORT
C
ONFIGURATION
config ports <portlist> auto off {speed [10 |
100 | 1000]} duplex [half | full]
Changes the configuration of a group of ports.
Specify the following:
■
auto off — The port will not autonegotiate
the settings.
■
speed — The speed of the port (for 10/100
Mbps or 100/1000 Mbps ports only).
■
duplex — The duplex setting (half- or
full-duplex).
config ports <portlist> auto on Enables autonegotiation for the particular port
type; 802.3u for 10/100 Mbps ports or 802.3z for
Gigabit Ethernet ports.
config ports <portlist> display-string <string> Configures a user-defined string for a port. The
string is displayed in certain show commands (for
example, show port all info). The string
can be up to 16 characters.
config ports <portlist> qosprofile <qosname> Configures one or more ports to use a particular
QoS profile.
config slot <slot> module [f32t | f32f | f48t |
g4x | g6x | g8x | g12x]
Configures a slot for a particular I/O module card.
disable jumbo-frame ports [<portlist> | all] Disables jumbo frame support on a port.
disable learning ports <portlist> Disables MAC address learning on one or more
ports for security purposes. If MAC address
learning is disabled, only broadcast traffic,
Extreme Discovery Protocol (EDP) traffic, and
packets destined to a permanent MAC address
matching that port number are forwarded to the
port. The default setting is enabled.
disable ports <portlist> Disables a port. Even when disabled, the link is
available for diagnostic purposes.
disable sharing <port> Disables a load-sharing group of ports.
enable jumbo-frame ports [<portlist> | all] Enables reception and transmission of jumbo
frames. A jumbo frame is dropped if it is received
on a port with jumbo frames disabled, or if the
jumbo frame needs to be forwarded out of a port
that has jumbo frames disabled.
enable learning ports <portlist> Enables MAC address learning on one or more
ports. The default setting is enabled.
enable ports <portlist> Enables a port.
Table 4- 1: BlackDiamond and Alpine Switch Port Commands (continued)
Command Description