User guide

E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
3-9
U
SING
E
XTREME
W
ARE
V
ISTA
For more information on assigning an IP address, refer to the section,
“Configuring Switch IP Parameters,” on page 3-3.
The default home page of the switch can be accessed using the following command:
http://<ipaddress>
When you access the home page of the switch, you are presented with the Logon
screen.
For more information on using ExtremeWare Vista, refer to Chapter 19.
C
ONTROLLING
W
EB
A
CCESS
By default, Web access is enabled on the switch. Use of ExtremeWare Vista Web access
can be restricted through the use of an access profile. An access profile permits or
denies a named list of IP addresses and subnet masks. To configure Vista Web access to
use an access profile, use the following command:
enable web {access-profile <access-profile> | none} {port
<tcp_port_number>
Use the
none
option to remove a previously configured access profile.
To display the status of Web access, use the following command:
show management
To disable ExtremeWare Vista, use the following command:
disable web
To re-enable Web access, use the following command:
enable web {access-profile <access-profile> | none} {port
<tcp_port_number>
When you disable or enable ExtremeWare Vista, you must reboot the switch for the
changes to take effect. Apply an access profile only when ExtremeWare Vista is enabled.