User guide

2-8 E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
A
CCESSING THE
S
WITCH
delete vlan <name> Deletes a VLAN.
disable bootp vlan [<name> | all] Disables BOOTP for one or more VLANs.
disable cli-config-logging Disables logging of CLI commands to the
Syslog.
disable clipaging Disables pausing of the screen display
when a show command output reaches
the end of the page.
disable idletimeout Disables the timer that disconnects all
sessions. Once disabled, console sessions
remain open until the switch is rebooted or
you logoff. Telnet sessions remain open
until you close the Telnet client.
disable port <portlist> Disables a port on the switch.
disable ssh2 Disables SSH2 Telnet access to the
switch.
disable telnet Disables Telnet access to the switch.
disable web Disables Web access to the switch.
enable bootp vlan [<name> | all] Enables BOOTP for one or more VLANs.
enable cli-config-logging Enables the logging of CLI configuration
commands to the Syslog for auditing
purposes. The default setting is enabled.
enable clipaging Enables pausing of the screen display
when show command output reaches the
end of the page. The default setting is
enabled.
enable idletimeout Enables a timer that disconnects all
sessions (both Telnet and console) after
20 minutes of inactivity. The default setting
is disabled.
enable license [full_L3 | service-provider | security]
<license_key>
Enables a particular software feature
license. Specify <license_key> as an
integer.
The command unconfig switch all
does not clear licensing information. This
license cannot be disabled once it is
enabled on the switch.
Table 2- 3: Common Commands (continued)
Command Description