User guide

19-2 E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
U
SING
E
XTREME
W
ARE
V
ISTA
E
NABLING AND
D
ISABLING
W
EB
A
CCESS
By default, Web access is enabled on the switch. Use of ExtremeWare Vista Web access
can be restricted through the use of an access profile. An access profile permits or
denies a named list of IP addresses and subnet masks. To configure Vista Web access to
use an access profile, use the following command:
enable web access-profile [<access-profile> | none] {port
<tcp_port_number>}
Use the
none
option to remove a previously configured access profile.
To display the status of Web access, use the following command:
show management
To disable ExtremeWare Vista, use the following command:
disable web
To re-enable Web access, use the following command:
enable web {access-profile [<access-profile> | none]} {port
<tcp_port_number>]
You will need to reboot the system in order for these changes to take effect.
For more information on rebooting, refer to Chapter 20.
To use ExtremeWare Vista, at least one VLAN must be assigned an IP address.
S
ETTING
U
P
Y
OUR
B
ROWSER
In general, the default settings that come configured on your browser work well with
ExtremeWare Vista. The following are recommended settings that you can use to
improve the display features and functionality of ExtremeWare Vista:
• After downloading a newer version of the switch image, clear the browser disk and
memory cache to see the updated menu screens. You must clear the cache while at
the main ExtremeWare Vista Logon screen, so that all underlying .GIF files are
updated.