User guide

16-26 E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
A
CCESS
P
OLICIES
on the ingress or egress side, depending on the change. For soft resets to be applied on
the ingress side, the changes must have been previously enabled on the neighbor.
Changes to profiles applied to OSPF typically require rebooting the switch, or
disabling and re-enabling OSPF on the switch.
R
EMOVING A
R
OUTING
A
CCESS
P
OLICY
To remove a routing access policy, you must remove the access profile from the routing
protocol or VLAN. All the commands that apply an access profile to form an access
policy also have the option of choosing
none
as the access profile. Using the
none
option removes any access profile of that particular type from the protocol or VLAN,
and, therefore, removes the access policy.
R
OUTING
A
CCESS
P
OLICY
C
OMMANDS
Table 16-3 describes the commands used to configure routing access policies.