User guide

E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
14-7
C
ONFIGURING
IP M
ULTICASTING
R
OUTING
Table 14-2 describes the commands used to configure the Internet Gateway Message
Protocol (IGMP).
config pim timer <hello_interval>
<jp_interval> vlan [<vlan> | all]
Configures the global PIM timers. Specify the
following:
hello_interval The amount of time
before a hello message is sent out by the PIM
router. The range is 1 to 65,519 seconds. The
default setting is 30 seconds.
jp_interval The join/prune interval. The
range is 1 to 65,519 seconds. The default
setting is 60 seconds.
config pim vlan [<name>| all ]
trusted-gateway [<access_profile> | none]
Configures PIM to use the access-profile to
determine the PIM trusted gateway.
enable dvmrp Enables DVMRP on the system. The default
setting is disabled.
enable dvmrp rxmode vlan [<name> | all] Enables receiving of DVMRP packets on a
per-VLAN basis.
enable dvmrp txmode vlan [<name> | all] Enables transmitting of DVMRP packets on a
per-VLAN basis.
enable ipmcforwarding {<vlan <name} Enables IP multicast forwarding on an IP
interface. If no options are specified, all
configured IP interfaces are affected. When new
IP interfaces are added, ipmcforwarding is
disabled by default.
enable pim Enables PIM on the system. The default setting
is disabled.
Table 14-1: IP Multicast Routing Configuration Commands (continued)
Command Description