User guide

9-26 E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
Q
UALITY
OF
S
ERVICE
(Q
O
S)
DLCS L
IMITATIONS
Consider the following limitations concerning data received from WINS snooping:
DLCS does not work for the WINS server. This is because the WINS server does not
send NETBIOS packets on the network (these packets are address to itself).
When the IP address of a host is changed, and the host is not immediately rebooted,
the old host-to-IP address mapping is never deleted. You must delete the mapping of
the host-to-IP address through the EEM Policy Manager.
When the host is moved from one port to another port on a switch, the old entry
does not age out unless the host is rebooted or a user login operation is performed
after the host is moved.
DLCS information is dynamic, therefore, if the switch is rebooted, the information is
lost. This information is still stored in the policy-server. To delete the information
from the policy system, you must explicitly delete configuration parameters from the
EEM Policy Applet user interface. As a workaround, you may delete the switch that
was rebooted from the list of managed devices in the EEM Inventory Applet, and
re-add the switch to the Inventory Manager.
DLCS is not supported on hosts that have multiple NIC cards.
IPQoS is not supported to a WINS server that is serving more than one VLAN. If
you attempt to add a WINS server to serve more than one VLAN, and there are
IPQoS rules defined for that server, the command to add the WINS server is rejected.
DLCS C
OMMANDS
The DLCS commands are described in Tabl e 9 -1 4.
Table 9-14: DLCS Configuration Commands
Command Description
clear dlcs Clears learned DLCS data.
config isq-server <wins-servers-listname>
add ipaddress <wins-server1>
Adds a WINS servername and IP address.
config isq-server <wins-servers-listname>
add mac <mac-address-of-next-hop> vlan
<vlan name>
Adds the MAC address of the next hop router.
config isq-server <wins-servers-listname>
delete ipaddress <wins-server1>
Deletes a WINS servername and IP address.