Specifications

46 ExtremeWare XOS 10.1 Concepts Guide
Managing the Switch
name also points to the filter profile used to filter the notifications. Finally, the notification tags are
added to a notification table so that any target addresses using that tag will receive notifications.
Target Addresses
A target address is similar to the earlier concept of a trap receiver. To configure a target address, use the
following command:
configure snmpv3 add target-addr {hex} <addr name> param {hex} <param name> ipaddress
<ip address> {volatile}
In configuring the target address you supply an address name that identifies the target address, a
parameters name that indicates the message processing model and security for the messages sent to the
target address, and the IP address and port for the receiver. The parameters name also is used to
indicate the filter profile used for notifications. The target parameters is discussed in the section “Target
Parameters”.
To display target addresses, use the following command:
show snmpv3 target-addr {{hex} <addr name>}
To delete a single target address or all target addresses, use the following command:
configure snmpv3 delete target-addr [{{hex} <addr name>} | all]
Target Parameters
Target parameters specify the message processing model, security model, security level, and user name
(security name) used for messages sent to the target address. See the sections “Message Processing” and
“Users, Groups, and Security” for more details on these topics. In addition, the target parameter name
used for a target address points to a filter profile used to filter notifications. When you specify a filter
profile, you associate it with a parameter name, so you need to create different target parameter names
if you use different filters for different target addresses.
Use the following command to create a target parameter name, and set the message processing and
security settings associated with it:
configure snmpv3 add target-params {hex} <param name> user {hex} <user name> mp-model
[snmpv1 | snmpv2c | snmpv3] sec-model [snmpv1 | snmpv2c | usm] {sec-level [noauth |
authnopriv | priv]} {volatile}
To display the options associated with a target parameters name, or all target parameters names, use the
following command:
show snmpv3 target-params {{hex} <param name>}
To delete one or all the target parameters, use the following command:
configure snmpv3 delete target-params [{{hex} <param name>} | all]
Filter Profiles and Filters
A filter profile is a collection of filters that specifies which notifications should be sent to a target
address. A filter is defined by a MIB subtree and mask, and by whether that subtree and mask is
included or excluded from notification.