Quick Start Guide

8 In the Scale Floor dialog, select Draw Boundary. (The area within the boundary is used to determine
device location.) To anchor the beginning of the boundary line, click a corner of the outside
boundary. Click each corner to anchor the line. The drawing line zigzags across the image as you
anchor each corner. When you reach the last corner (which is also your starting point), double-click
the last corner to disable the pen tool.
The entire outside boundary is drawn and the Scale button is enabled.
Note
If you make a mistake, select Clear Boundary to remove the entire boundary and start
over.
9 Select Scale. Choose two points on the floor map for which you know the actual physical distance.
Click on the first point and drag your pointer to the other point.
Note
Proper scaling is fundamental to the accuracy of the location data for this site. Verify that
the scaling information is as accurate as possible.
A line is drawn on the map between the two points.
10 Enter the physical distance value in the Scale Floor dialog.
Figure 24: Add Scaling
11 Enter the height at which the access point is installed. This information is required for increasing the
accuracy of device tracking within this floor.
Access point height can be in Meters or in Feet.
ExtremeLocation Quick Setup
ExtremeLocation Quick Start Guide 53