Release Notes
Table Of Contents
- Extreme Management Center® Release Notes Version 8.5.1
- Table of Contents
- Extreme Management Center Version 8.5 Release Notes
- 1. Enhancements in Version 8.5.1
- 2. Deprecated Features
- 3. Known Issues and Vulnerabilities Addressed
- 4. Installation, Upgrade, and Configuration Changes
- 4.1 Installation Information
- 4.2 Important Upgrade Considerations
- 4.3 ExtremeAnalytics Upgrade Information
- 4.4 ExtremeControl Upgrade Information
- 4.5 Fabric Configuration Information
- 4.6 Device Configuration Information
- 4.7 Firmware Upgrade Configuration Information
- 4.8 Wireless Manager Upgrade Information
- 5. System Requirements
- 5.1 Extreme Management Center Server and Client OS Requirements
- 5.2 Extreme Management Center Server and Client Hardware Requirements
- 5.3 Virtual Engine Requirements
- 5.4 ExtremeControl Agent OS Requirements
- 5.5 ExtremeControl Supported End-System Browsers
- 5.6 ExtremeControl Engine Version Requirements
- 5.7 ExtremeControl VPN Integration Requirements
- 5.8 ExtremeControl SMS Gateway Requirements
- 5.9 ExtremeControl SMS Text Messaging Requirements
- 5.10 ExtremeAnalytics Requirements
- 5.11 Ekahau Maps Requirements
- 5.12 Guest and IoT Manager Requirements
- 6. Getting Help
4. Installation, Upgrade, and Configuration Changes
39 of 51
(config)# autotopology
(config)# sys force-topology-ip-flag enable
(config)# default sys clipId-topology-ip
The
Status of LAGlinks in maps will start working after the next polling following an
upgrade to Extreme Management Center version 8.4. You can initiate the polling of a
device by performing a refresh/rediscovery of the device.
4.6.3 ERS Device Configuration
ERS devices might automatically change VLAN configurations you define in Extreme
Management Center. To disable this, change the vlan configcontrol setting for
ERS devices you add to Extreme Management Center by entering the following in the
device command line:
CLI commands
enable
config term
vlan configcontrol flexible
Additionally, configure all VLANs on the port for an ERS device with the same tag status
(tagged or untagged). If enforcing to an ERS device on which a port has at least one
VLAN as tagged, Extreme Management Center adds all untagged VLANs to the tagged
VLAN list and clears the untagged VLAN list.
Creating an archive for ERS devices using the Network > Archives tab does not
complete successfully if Menu mode (cmd-interface menu) is used instead of CLI mode
(cmd-interface cli). Use CLI mode to create the archive.
4.6.4 SLX Device Configuration
When creating a ZTP+ Configuration for an SLX 9240 on which firmware version
18s.01.01 or 18s.01.02 is installed, the ZTP+ process fails if the Administration Profile
value uses SSH or Telnet CLI credentials. Extreme Management Center indicates that
the SSH or CLI profile is not supported by the device.
To create a ZTP+ configuration for an SLX 9240: