Release Notes

4. Installation, Upgrade, and Configuration Changes
38 of 51
Manager > SCP tab contains a password that includes an ampersand (&) in Extreme
Management Center, the Fabric Manager firmware does not download successfully.
Ensure you use a password without an ampersand (&) character.
4.5.9 VRFConfiguration
VSP SNMP performance is adversely affected as the number of VRF configurations
increases. This issue can be resolved by upgrading to VSP release 8.1.1 or later or
VSP8600 series version 6.3.3 or later.
4.6 Device Configuration Information
4.6.1 VDX Device Configuration
To properly discover interfaces and links for VDX devices in Extreme Management
Center, enable three-tuple-if on the device.
NOTE: To enable three-tuple-if on the device in Extreme Management Center:
1. Access the Network > Devices tab.
2. Right-click on the device in the Devices table.
3. Select Tasks > Config > VDX Config Basic Support.
Additionally, for Extreme Management Center to display VCSfabric , the NOSversion
must be 7.2.0a or later.
Rediscover VDX devices after upgrading to Extreme Management Center version 8.4.2.
4.6.2 VSP Device Configuration
Topology links from VSP devices to other VSP or ERS devices might not display in a
topology map (or might display inconsistently). To ensure topology map links display
correctly, verify that the VSP device is configured to publish its management IP address
in the autotopology (SONMP) data.
Ensure that the output of show sys setting command shows:
autotopology : on
ForceTopologyIpFlag : true
clipId-topology-ip : 0
If the output values displayed are different, configure the VSP device to publish
management IP address in SONMP data by executing the following CLI commands: