Configuration Guide
Table Of Contents
- ExtremeControl Guest and IoT Manager Configuration
- Extreme Networks® Software License Agreement
- Table of Contents
- About this Document
- New in this Document
- Guest and IoT Manager Overview
- Installing Guest and IoT Manager
- Administering Guest and IoT Manager
- Configuring Onboarding Template
- Creating an Onboarding Template
- Configuring the Common Details
- Configuring the Guest User Account Details
- Configuring Sponsor Approval
- Configuring the Device Record Details
- Configuring Device Type Groups
- Configuring the Account Notification Templates
- Configuring Advanced Details
- Configuring Guest User Provisioning Using Outlook Add-in
- Configuring Guest User Provisioning Using Vouchers
- Configuring Guest User and Device Provisioning Using CSV
- Configuring Device Record Details
- Configuring Zero Touch Guest User Provisioning
- Managing Onboarding Templates
- Configuring Custom Attributes
- Configuring Access Groups
- Creating an Onboarding Template
- Configuring Provisioners
- Configuring Self-Services
- Managing Guest Users
- Managing Devices
- Configuring Guest and Devices
- Using Self-Provisioning Services
- Guest and IoT Manager Add-In for Outlook
- Automated Login of the Guest User using the Login URL
- Troubleshooting and FAQs
- Testing RADIUS Connection Settings
- Restarting Guest and IoT Manager
- Problem: Virtual Appliance Troubleshooting
- Problem: Saving Access Control Engine Settings
- Problem: User Groups / End System Group Not Visible in Guest and IoT Manager
- Problem: Provisioner Cannot Login
- Problem: Guest and IoT Manager Email / SMS Notification Failed
- Problem: Unable to Access Guest and IoT Manager Application URL
- Problem: User and Device Troubleshooting
- Problem: Sponsor List is Not Available
- Problem: Modification in Network Interface settings does not reflect post dep...
- Problem: Outlook Add-in Issues
- Problem: Service Unavailable in Browser
- Problem: Time Zone Issues for Schedule Tasks
- Problem: Users/Devices are not getting cleaned up for Housekeeping Tasks
- Problem: Unable to Access GIM UI
- Problem: LDAP Provisioner login fails
- Problem: LDAP Sponsors are not populating in the Self-Service Page
- Problem: Server Error during bulk creation
- Problem: Unable to Renew Password
- Problem: Guest User account is not created post sending SMS
- Problem: Login URL redirects to Captive Portal
- Problem: “Server Error. Please contact Administrator Error message on clickin...
- Problem: FQDN not being used in URLs
- Problem: Unable to Customize Provisioner Login page
- Problem: Login failed. Invalid credentials/Account Expired” message on clicki...
- Problem: Outlook Add-in throws Security Exception post enabling FQDN
- Command Line Interface
Problem: Unable to Access GIM UI
273 of 291
Problem: Unable to Access GIM UI
Problem
Unable to access the GIM UI after having disabled and then enabled the interface
or after doing a restore operation or after reboot.
Solution
Some routes are deleted when the GIM interfaces are disabled or when GIM VM
is rebooted.
Check if the added routes are deleted after having disabled the interface or after
rebooting.
If there are some routes that are disabled, then add the routes manually and
restart tomcat.
<interface <Port> ipaddr <ip address/netmask>
<route add <dest ip > gateway
Problem: LDAP Provisioner login fails
Problem
LDAP login fails with a Server Error. In the logs, an error 'Login successful but No
Onboarding Templates recived form NAC' is displayed, indicating that no
Onboarding template was received from NAC.
Solution
This occurs when the LDAP Provisioner is not mapped to any Onboarding
Template.
In the Onboarding Template(s) – Advanced section, check the following:
l If the Default Onboarding Template for LDAP Provisioner checkbox is selected
OR