Release Notes

3. Known Issues and Vulnerabilities Addressed
34 of 69
IP Addresses or device names had to be entered manually when
adding entries to a Location Group in the Group Editor panel. A
new Select Devices button, which allows users to select from a
list of network devices, has been added.
1738208
01868775
The flow collector was attempting to apply a port-based IDs to
flows with no identification without checking if the matching
port-based fingerprint was enabled.
01855275
Packet capture was being applied to all switches, regardless of
whether the switches reported the flow selected for capture,
causing a delay in responsiveness. Packet capture now only
applies to those switches that reported the flow selected by the
user, and multiple packet captures for a single IP address are
processed simultaneously.
01849005
Creating a Location Group with an Interface of Wireless and all
other options set to Any was matching wired end-systems.
------
ZTP+ was unable to upgrade and onboard new devices when
/world was configured to Updates = Never for configuration and
firmware upgrades.
1941725
On ZTP+ image upgrades, special characters in the Extreme
Management Center username or password caused the upgrade
to fail.
------
Custom time filters in Alarms and Events were discarded when
new events occurred.
01937890
01919341
In the legacy console, the graphing function for Port Utilization in
Percent was not rendering and the Utilization in Percent option
was not displaying.
01923651
Some table columns in Extreme Management Center did not sort
in numeric order.
01937793
In Extreme Management Center, when a map was exported as an
SVG image, the device images did not render correctly.
------
For ZTP+, the Use Discovered checkbox did not allow customers
to select whether to use the discovered IP or use both the
discovered IP and management interface.
01925201
The Device Restart operation for VSP8606 reported a failure
when the reset operation was successful.
------