Installation Guide

Changing ExtremeAnalytics Engine Settings
30 of 39
This starts the network configuration script and allows you to make the required
changes. You must reboot the engine for the new settings to take effect.
Changing SNMP Configuration
To change SNMP configuration settings such as SNMP Trap Community String,
SNMP User, SNMP Authentication, and SNMP Privacy credentials, enter the
following command at the engine CLI:
/usr/postinstall/snmpconfig
This starts the SNMP configuration script and allows you to make the required
changes.
Changing Date and Time Settings
To enable or disable using NTP to configure the engine date and time, or to
manually set the date and time on the engine, enter the following command at
the engine CLI:
/usr/postinstall/dateconfig
This starts the date and time configuration script and allows you to change the
settings.
Changing the Management Center Server IP Address
To change the IP address of the Management Center server, enter the following
command at the engine CLI:
/opt/appid/configMgmtIP <ipaddress>
Enter the following command to start using the new Management Center server:
service appidserver restart
Changing the Web Service Credentials
The Web Service credentials provide access to the ExtremeAnalytics Engine
Administration web page and the web services interface for the
ExtremeAnalytics engine. Engines are shipped with a preconfigured default
password.