Installation Guide
Table Of Contents
- Table of Contents
- About This Guide
- Engine Overview and Setup
- Configuration
- Reinstalling Engine Software
- Product Regulatory and Compliance Information
Changing ExtremeAnalytics Engine Settings
29 of 39
The Add ExtremeAnalytics Engine window displays.
3. Enter the IP Address of the eth0 interface and the Name of the ExtremeAnalytics
engine.
4. Select the appropriate SNMP Profile from the Profile drop-down list.
5. Click OK.
6. Select Enforce Engine from the drop-down list.
The ExtremeAnalytics engine is added to Management Center.
Changing ExtremeAnalytics Engine Settings
Use these steps if you need to change your ExtremeAnalytics engine settings
following your initial engine configuration.
Changing Basic Network Configuration
To change basic network configuration settings such as hostname and engine IP
address, enter the following command at the engine CLI:
/usr/postinstall/dnetconfig