Installation Guide

Launching the ExtremeAnalytics Application
26 of 39
==========================================================
======
Modify Settings
==========================================================
======
All of the information needed to complete the installation of the
ExtremeAnalytics Engine has been entered. Enter 0 or any key other
than a valid selection to continue. If you need to make a change, enter
the appropriate number from the choices listed below.
==========================================================
======
0. Accept settings and continue
1. Set the root user password
2. Set user to run server as
3. Set hostname and network settings
4. Set SNMP settings
5. Set the system time
6. Modify all settings
Enter selection [0]:
The ExtremeAnalytics application software is automatically installed. This may
take a few minutes. When the installation is complete, you see the following
screen.
==============================================================
===
Extreme Networks - ExtremeAnalytics Engine - Setup Complete
==============================================================
===
Setup of the ExtremeAnalytics Engine is now complete. The engine is now
operational and ready to accept remote connections. Details of the
installation are located in the /var/log/install directory.
==============================================================
===
Launching the ExtremeAnalytics Application
Now that you have configured the ExtremeAnalytics engine, you are ready to
access the Extreme Management Center Launch Page and run the applications