Installation Guide

Configuring the ExtremeAnalytics Engine
20 of 39
10. Enter the IP addresses for one or more GRE tunnels. For each line, type the
requested configuration information and press [Enter].
==========================================================
====== ExtremeAnalytics Engine GRE Configuration
==========================================================
======
Remote mirroring can be configured in Coreflow Switches using GRE
tunnels. This requires a specific mirroring configuration enabled on
the switches.
Enter the SRC IP address for the GRE Tunnel [10.54.211.116]:
Enter the DST IP address for the GRE Tunnel [192.168.1.1]: 10.54.1.116
Add another GRE Tunnel (y/n) [n]? y
Enter the SRC IP address for the GRE Tunnel [10.54.222.117]:
Enter the DST IP address for the GRE Tunnel [192.168.1.1]: 10.54.2.117
Add another GRE Tunnel (y/n) [n]? n
11. A screen appears asking you to confirm your network setting. Enter 0 to accept the
settings.
The following example shows the Confirm Network Settings screen for
deployment mode 1.
==========================================================
======
Confirm Network Settings
==========================================================
======
These are the settings you have entered. Enter 0 or any key other
than a valid selection to continue. If you need to make a change, enter
the appropriate number now or run the /usr/postinstall/dnetconfig
script at a later time.
==========================================================
======
0. Accept settings and continue
1. Hostname: pv88
2. Deployment Mode: Dual Interface Mirrored
3. Management Interface Configuration (eth0):