Installation Guide
Table Of Contents
- Table of Contents
- About This Guide
- Engine Overview and Setup
- Configuration
- Reinstalling Engine Software
- Product Regulatory and Compliance Information
Configuring the ExtremeAnalytics Engine
19 of 39
l For deployment mode 2, proceed to step 8.
8. Specify one or more tap ports. If you have an installed optional PV-A-300-10G-UG
I/O module, the ports are eth4 and eth5. For each line, type the requested
configuration information and press [Enter].
==========================================================
====== ExtremeAnalytics Engine Network Configuration for Tap Mode
==========================================================
======
Enter the interface name for Tap Mode [eth1]: eth4
Would you like to add another interface for Tap Mode (y/n) [n]? y
Enter the interface name for Tap Mode [eth2]: eth5
Would you like to add another interface for Tap Mode (y/n) [n]? n
Proceed to step 10.
9. Specify one or more GRE tunnel interfaces. If you have an installed optional PV-A-
300-10G-UG I/O module, the ports are eth4 and eth5. For each line, type the
requested configuration information and press [Enter].
==========================================================
====== ExtremeAnalytics Engine Network Configuration for Tunnel
Interfaces
==========================================================
======
Enter the interface name for Tunnel Configuration [eth1]: eth4
Enter information below to configure eth4
Enter the IP address for eth4 on pv88 [10.54.211.116]:
Enter the IP netmask [255.255.255.0]:
Enter the gateway address [10.54.211.1]:
Would you like to add another interface for Tunnel Configuration
(y/n) [n]? y
Enter the interface name for Tunnel Configuration [eth1]: eth5
Enter information below to configure eth5
Enter the IP address for eth5 on pv88 [10.54.222.117]:
Enter the IP netmask [255.255.255.0]:
Enter the gateway address [10.54.222.1]:
Would you like to add another interface for Tunnel Configuration
(y/n) [n]? n