Installation Guide

Configuring the ExtremeAnalytics Engine
18 of 39
its own IP Address and GRE Tunnels will be configured for traffic
monitoring. Suitable for feeds from Coreflow switches.
4. Manual Mode - The interface and tunneling configurations will not
be modified by this script, leaving them to be manually edited by the
user instead.
Please select a deployment mode [2]:
Note: If you select deployment mode 4, refer to the Extreme
ExtremeAnalytics Deployment Guide for information on how to
configure your deployment manually.
6. If you selected deployment mode 0, 1, 2, or 3 the ExtremeAnalytics Engine Network
Configuration for eth0 screen appears. For each line, type the requested
configuration information and press [Enter].
If you will be using DNS, provide the IP address of the name server. If
you are using a name server enter a domain name for the engine. The
NIS server is used to authenticate users logging into the engine. If you
are using an NIS server, make sure the NIS domain name is valid or
users may not be able to log in to the Management Center
applications.
==========================================================
====== ExtremeAnalytics Engine Network Configuration for eth0
==========================================================
======
Enter information below to configure eth0
Enter the hostname for the engine (Required):
Enter the IP address for eth0 on 10.54.56.141 [10.54.56.141]:
Enter the IP netmask [255.255.255.0]:
Enter the gateway address [10.54.56.2]:
Enter the IP address of the name server (Optional):
Enter the domain name for 10.54.56.141 (Optional):
Enable NIS (y/n) [n]?
7. Continue to the appropriate section:
l For deployment mode 0, proceed to step 9.
l For deployment mode 1, proceed to step 7.