Installation Guide

Changing ExtremeAnalytics Engine Settings
63 of 65
3. Enter the following information:
l IP address of the eth0 interface
l Name of the ExtremeAnalytics engine
4. From the Profile list, select the appropriate SNMP profile.
5. Click OK.
6. Open the drop-down list below Overview and select Enforce Engine.
Changing ExtremeAnalytics Engine Settings
Use these steps if you need to change your ExtremeAnalytics virtual engine
settings following your initial engine configuration. Perform these steps in the
vSphere client Console tab.
Changing Basic Network Configuration
To change basic network configuration settings such as hostname and engine IP
address, enter the following command at the login prompt in the Console tab:
/usr/postinstall/dnetconfig
This will start the network configuration script and allow you to make the
required changes. You must reboot the engine for the new settings to take
effect.
Changing SNMP Configuration
To change SNMP configuration settings such as SNMP Trap Community String,
SNMP User, SNMP Authentication, and SNMP Privacy credentials, enter the
following command at the login prompt in the Console tab:
/usr/postinstall/snmpconfig
This will start the SNMP configuration script and allow you to make the required
changes.
Changing Date and Time Settings
To enable or disable using NTP to configure the engine date and time, or to
manually set the date and time on the engine, enter the following command at