Installation Guide

Configuring the ExtremeAnalytics Engine
57 of 65
VMs that are hosted on the VMS server).
==========================================================
Configure Date And Time Settings
==========================================================
The appliance date and time can be set manually or using
an external Network Time Protocol (NTP) server. It is
strongly recommended that NTP is used to configure the
date and time to ensure accuracy of time values for SNMP
communications and logged events. Up to 5 server IP
addresses may be entered if NTP is used.
==========================================================
Do you want to use NTP (y/n) [y]? y
Please enter a NTP Server IP Address (Required):
144.131.10.120
Would you like to add another server (y/n) [n]? y
15. The NTP validate selection screen displays. Enter 0 to accept the current settings
and proceed to the Set Time Zone screen at step 17.
==========================================================
NTP Servers
==========================================================
These are the currently specified NTP servers. Enter 0 or
any key other than a valid selection to complete NTP
configuration and continue.
If you need to make a change, enter the appropriate number
from the choices listed below.
144.131.10.120
0. Accept the current settings
1. Restart NTP server selection
2. Set date and time manually
==========================================================
Enter selection [0]: 0
16. If you answered no to using an NTP server to set date and time, the following
manual set date and time screen appears.