Installation Guide

Configuring the Extreme Management Center Engine
26 of 65
==========================================================
======
The following information will be used to configure SNMP
management of this device. The SNMP information entered here must
be used to contact this device with remote management applications
such as Extreme Management Center Console.
==========================================================
======
Please enter the SNMP user name [snmpuser]:
Please enter the SNMP authentication credential [snmpauthcred]:
Please enter the SNMP privacy credential [snmpprivcred]:
8. In the SNMP Configuration summary screen, enter 0 to accept the settings.
==========================================================
======
SNMP Configuration
==========================================================
======
These are the current SNMP V3 settings. To accept them and complete
SNMP configuration, enter 0 or any key other than the selection
choices. If you need to make a change, enter the appropriate number
now or run the /usr/postinstall/snmpconfig script at a later time.
0. Accept the current settings
1. SNMP User: snmpuser
2. SNMP Authentication: snmpauthcred
3. SNMP Privacy: snmpprivcred
4. Modify all settings
==========================================================
======
Enter selection [0]: 0
9. In the Configure Date and Time Settings screen, select whether you want to use an
external Network Time Protocol (NTP) server. Enter y to use NTP, and enter your
NTP server IP address(es). Enter n to configure the date and time manually and
proceed to step 11.
Note that your VMS server should be using the same NTP settings as
those configured for your virtual engine (i.e., the same settings as the
VMs that are hosted on the VMS server).