Manualshelf

Installation Guide

ManualsBrandsExtreme Networks ManualsComputers & AccessoriesReal-time Network and Application Insights from the Edge to the Data Center and into the Multi-Cloud
21222324252627282930
Table Of Contents
Post-installation conguration
This chapter provides information about the steps to be performed in XMC to discover and display the device.
Perform the following steps:
1. Login to XMC and verify that the Virtual Sensor device is displayed in the Discovered tab.
2. Right-click the device and click Congure Devices.
a) In the Device tab, set the Administration Prole. For more information, see the section Device.
b) Click the ZTP+ Device Settings tab to congure the ZTP+ settings. For more information, see the section ZTP+ Device
Settings.
3. Click Save. The Status column changes to ZTP+ Staged.
After a few minutes, the device appears in the Devices tab. For more information, see the section Devices.
ExtremeAnalytics Virtual Sensor 1.0.0 Software Installation Guide
9036611-00 29