Installation Guide
Table Of Contents
- Table of Contents
- Preface
- Overview
- Virtual Appliance Deployment
- Virtual Appliance Configuration
- Access the Virtual Appliance Console
- Configure the VE6120/VE6125 using the Basic Configuration Wizard
- Set up the VE6120/VE6125 Appliance using the Basic Configuration Wizard
- Upgrade the VE6120/VE6125 Software
- Set Up the Virtual Appliance to Accept USB Flash Drives
- Generate and Install the Activation Package
- Subscription License
- Permanent Capacity License
- Configure vSwitches for the Virtual Appliance
- Configure a Virtual Machine to Gain Networking Performance
- Shut Down and Restart a Virtual Machine
- Index
8. Review the settings and then click Finish to add the USB device to VE6120 or click Cancel to abort
the operation.
The Virtual Machine Properties dialog displays that the USB device is in the process of being added
to the virtual machine. The new USB device will be shown in bold and “adding” appears after the
USB device name.
9. Click OK to save the configuration.
10. Open the VE6120 Virtual Machine Properties dialog from the main vSphere client screen and click
the Hardware tab.
The USB device will be listed under Hardware. You can now use the USB flash drive on the VE6120
just as you would on a physical controller.
Manage the Flash Memory
About This Task
Follow these steps to manage flash memory:
Procedure
1. Log into the Extreme Campus Controller using your credentials.
Manage the Flash Memory Virtual Appliance Configuration
34 VE6120/VE6125 Virtual Appliances Installation Guide VMware® Platform for version 5.16.01