Installation Guide

3. Pick a number according to the region numbers that is displayed on screen to pick you continent.
Then, enter a number that corresponds to the Region. You can enter n to move down the list, or p to
move up the list. To go back to the Region selection, press c.
4. Press Enter to run NTP as a client.
5. Provide the fully qualified domain name of the NTP server. Press Enter.
6. You are prompted to enter a second NTP server and the default option is y. Type n and press Enter.
NTP Client is enabled.
7. Accept the changes you have made to the time zone and NTP server by pressing Enter.
You are navigated to the Controller Post Installation
Configuration screen along with the menu.
8. If you want to revisit any of the previous screens or exit without applying the configuration changes,
enter one of the corresponding numbers/alphabets displayed on screen.
Figure 13: Controller Post Installation Configuration Menu Screen
Table 6: Controller Post Installation Configuration Menu
Menu Option Command
Admin password Configuration 1
Change AP Password 2
Change Data Port Settings 3
Change Host Attribute Settings 4
Change Global Default Gateway Settings 5
Change Time Settings 6
Apply Settings and Exit A
Exit Without Applying E
When you revisit any other screen, you will have to reconfigure all subsequent area settings. For
example, if you decide to reconfigure the Admin Password, which is at the beginning of the
configuration wizard, you will have to reconfigure all the subsequent configuration wizard settings.
Press Enter to accept the settings. The default option for accepting the settings is A. Your settings
are now applied successfully.
Current Time Settings
Virtual Appliance Configuration
28 VE6120/VE6125 Virtual Appliances Installation Guide VMware® Platform for version 5.16.01