Installation Guide
Table Of Contents
- Table of Contents
- Preface
- Overview
- Virtual Appliance Deployment
- Virtual Appliance Configuration
- Access the Virtual Appliance Console
- Configure the VE6120/VE6125 using the Basic Configuration Wizard
- Set up the VE6120/VE6125 Appliance using the Basic Configuration Wizard
- Upgrade the VE6120/VE6125 Software
- Set Up the Virtual Appliance to Accept USB Flash Drives
- Generate and Install the Activation Package
- Subscription License
- Permanent Capacity License
- Configure vSwitches for the Virtual Appliance
- Configure a Virtual Machine to Gain Networking Performance
- Shut Down and Restart a Virtual Machine
- Index
Current Host Attributes
About This Task
To set up the current host attributes,
Procedure
1. Press Enter to change the Host Attributes.
2. Press Enter to enter the host name for the application.
3. Type Y to set up a dedicated Admin port for out-of-band management. The default option is no.
A note is displayed that the Admin port does not allow device registration.
4. Type the IP address in the following format xx.xx.xx.xxx to set up the IP address for the Admin
Port.
5. Press Enter to accept the default IP netmask for the Admin Port.
6. Press Enter to accept the default domain name for the appliance. The default domain name is
extremenetworks.com.
7. Press Enter to configure your Primary DNS server.
8. Type another IP address xx.x.xx.xx to set up the IP address of the Primary DNS and press Enter.
9. The default option to set up a Secondary DNS server is no. Press Enter to accept the default option.
The updated Host Attribute settings are displayed. To accept the changes you have made, press
Enter. The Current Global Default Gateway Settings CLI is displayed.
Current Global Default Gateway Settings
About This Task
The global default gateway can be on any Admin or data port topology/subnet.
Procedure
1. Type an IP address.
2. Press Enter to accept the changes.
You are navigated to the Current Time Settings CLI.
Current Time Settings
About This Task
The Current Time Settings option allows you to change the time zone as per your location.
Procedure
1. Press Enter to change the Time settings.
2. Press Enter again if you would like to change the Time Zone. The Region number list is displayed.
Important
Ensure that Extreme Campus Controller is configured with the correct Network Time
Protocol (NTP) Server settings. Licensing management and several other system functions
are dependent on an accurate timestamp. Configure NTP settings on Extreme Campus
Controller during the initial setup wizard or alternatively under Administration > System >
Network Time (as a first configuration step).
Virtual Appliance Configuration Current Host Attributes
VE6120/VE6125 Virtual Appliances Installation Guide VMware® Platform for version 5.16.01 27