User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
The AP reports the AP Name and Power Source. Power Source values include normal and restricted
levels for the following:
• AF
• AT
Switch
When both LLDP (Link Layer Discovery Protocol) and TLV (Type Length Value) advertisement are
enabled, the switch reports the Switch Port and System Name. If only the LLDP is enabled, the
switch Port Number displays. If the LLDP is not enabled on the switch, the switch is a gray icon.
Extreme Campus Controller
Extreme Campus Controller reports the controller Connectivity Status and IP address.
The connection status is indicated as follows:
Green
• A green lightning icon with a green icon border indicates that the AP power level is normal.
• A green shield on the controller indicates that an AP secure tunnel is enabled for the AP
connection to Extreme Campus Controller.
• A green line indicates that the port speed between the AP and switch is the maximum AP port
speed. Refer to Table 15 on page 80.
Yellow
• A yellow lightning icon with a yellow icon border indicates that the AP power level is low.
• A yellow line indicates that the port speed between the AP and switch is less than the maximum
AP port speed. Refer to Table 15 on page 80.
Red
• A red shield on the controller indicates that an AP secure tunnel is disabled for the AP
connection to Extreme Campus Controller.
Table 15: Port Speeds per Access Point
AP Model Port 1 Port 2
AP3xx 1Gb (PoE) 1Gb
AP4xx 2.5Gb (PoE) 1Gb
AP505 2.5Gb (PoE) 1Gb
AP510i/e, AP510-1i, AP560i/h 5Gb (PoE) 1Gb (PoE)
AP4000 2.5Gb (PoE) 1Gb
Note
The Topology map is not supported on AP39xx access points.
Note
If you have configured the selected AP on an associated floor plan, you can view the selected
AP on the floor plan map from here. Select Map to view the selected AP on the floor plan. For
more information, see Floor Plan View on page 50.
Access Points List Monitor
80 Extreme Campus Controller User Guide for version 5.46.03