User's Guide

Working with SNMP Notifications on page 374
Working with SNMPv2 Communities on page 373
Working with SNMP Notifications
To work with SNMP notifications:
1. Go to Administration > System > Settings > SNMP.
2. Find the SNMP Notifications field.
3. To add a notification:
a. Click Add.
b. Enter the following:
• Notification name
• SNMP version
• IP address and UDP Port of the server that will receive SNMP messages.
c. Click Add.
Note
You can create two trap destinations for SNMP Notification. Set the type of message that
you will trap from the Forward Trap field on the SNMP configuration page.
4. To modify notification settings, select a notification from the list and select Edit.
5. To delete a notification, select a notification from the list and select Delete.
Related Topics
SNMP Configuration on page 371
Working with SNMPv3 Users on page 373
MAC Format
Extreme Campus Controller provides the ability to define the user MAC address format for MAC-based
authentication. Select from a set of MAC encoding formats, to match the format that you are using in
your existing authentication infrastructure.
Select the MAC address format and click Save.
Related Topics
Settings on page 371
AP Transmit Power Representation
You have the option to display AP power representation per chain or total power per radio for the
ExtremeWireless 11ax access points.
The benefits of configuring power representation per chain, is to accommodate for dierent radio
operation modes, including low power modes, which are smaller values than total radio power. Based
on the AP Transmit Power Representation setting, the following AP related information is aected:
• Calculations and configuration related to the operational mode or antenna configuration.
• Displayed statistics and reported values from the AP to the appliance.
Settings
Administration
374 Extreme Campus Controller User Guide for version 5.46.03