User's Guide

Set a Logging Filter
Create Date/Time filters to display entries that were logged within a specific window of time. To set a
date and time filter for an Extreme Campus Controller:
1. Go to Tools > Logs.
2. To display the Start Date/Time dialog, select Change.
3. From the Time field, specify the hour and minutes and select AM or PM.
4. To set both the start and end dates, in the Date field, use the arrows to navigate to the month, then
select the calendar day for the start date. Repeat to select the end date.
5. Select OK.
Entries that occur between the start and end date display. The filtered list will persist during your
session. You can navigate away from the page and return to the same filtered list. However, the filter is
cleared after you log out or reboot the controller.
Diagnostics
Extreme Campus Controller oers diagnostic tools to help you troubleshoot your network.
Go to Tools > Diagnostics.
Related Topics
TCP Dump Management on page 342
Network Utilities
Use wireless controller utilities to test a connection to the target IP address (or Fully-Qualified Domain
Name) and record the route through the Internet between your computer and the target address. You
can also use controller utilities to capture exception trac, which can be useful for network
administrators when debugging network problems.
Configure the following parameters:
Table 87: Network Utilities
Field Description
Target IP Address or Fully-Qualified
Domain Name (FQDN)
IP address or FQDN for the test target.
Use specific source interface Indicates if a specific interface will be selected for the test.
Select the interface from the Select Interface field.
When this option is cleared, Extreme Campus Controller runs
the test based on the interface selected in the routing table.
Select Interface Used with Specific Source Interface option. See list of possible
interfaces on the Interface tab.
Tools Set a Logging Filter
Extreme Campus Controller User Guide for version 5.46.03 341