User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Example: Network Modification
1. Go to Tools > Workflow and select the Network icon.
2. If there is more than one network available, select a specific network from the list.
(If there is only one network, the network configuration settings display.)
The specific network gains focus at the center of the Workflow page.
3. Select the specific network that has the focus to display the network configuration settings.
Related Topics
Add or Edit a Configuration Profile on page 122
WLAN Service Settings on page 221
AP Upgrade Report
The AP Upgrade Status Report provides the progress status of the AP upgrade request. View
information on the AP group or drill down to view the status of each individual AP in the group.
The AP group is identified by the Upgrade Request Time. Each request is considered a group. A group
must consist of APs that support the same firmware version. For example, currently all AP39xx series
APs support firmware version: 10.51.15.0002.img and all 11ax APs support firmware version:
7.5.0.0-005R.img.
Each Extreme Campus Controller release includes default AP firmware versions for the supported APs.
You can install additional firmware versions if necessary. Before initiating an AP Upgrade Request, verify
that the AP firmware is installed on Extreme Campus Controller.
For each group, the report displays the upgrade status percentage, the estimated completion time, and
the actual completion time. To display this same information for each AP in the group, select the group.
Figure 83: AP Upgrade Report
The AP upgrade status is color coded:
• Green indicates the percentage completed.
• Mustard indicates the percentage scheduled.
• Blue indicates the percentage in progress.
• Red indicates the percentage failed.
AP Upgrade Report
Tools
334 Extreme Campus Controller User Guide for version 5.46.03