User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
ExtremeGuest Captive Portal Settings on page 251
ExtremeGuest Server Settings
To configure the ExtremeGuest server, take the following steps:
1. Go to Configure > ExtremeGuest and select Add.
2. Configure the following parameters:
IP Address
IP address of the ExtremeGuest server.
Name
Name of the ExtremeGuest server.
FQDN
Fully-qualified domain name of the ExtremeGuest server.
Authentication Timeout Duration (Seconds)
Determines a timeout value, in seconds, for the RADIUS server connection.
Authentication Retry Count
Determines the number of times Extreme Campus Controller will attempt to authenticate an end
user.
Authentication Client UDP Port
User Datagram Protocol (UDP) port number used for client authentication. UDP needs only one
port for full-duplex, bidirectional trac.
Shared Secret
The password that is used to validate the connection between Extreme Campus Controller and
the ExtremeGuest server.
Mask — Determines if the Shared Secret or password value is displayed on the user interface.
Enable Mask to display dots in place of the Shared Secret or password value. To display the
password characters, clear the Mask check box.
Callback User Name
User ID that Callback Manager uses to access the ExtremeGuest server.
Callback Password
The password that Callback Manager uses to access the ExtremeGuest server. The minimum
password length is 6 characters.
Mask — Determines if the Shared Secret or password value is displayed on the user interface.
Enable Mask to display dots in place of the Shared Secret or password value. To display the
password characters, clear the Mask check box.
Related Topics
ExtremeGuest Captive Portal Settings on page 251
ExtremeGuest Integration on page 286
Configure
ExtremeGuest Server Settings
Extreme Campus Controller User Guide for version 5.46.03 287