User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
configure virtual-network IDAP add remote-endpoint vxlan ipaddress 10.47.100.108 vr VR-
Default
configure virtual-network IDAP add remote-endpoint vxlan ipaddress 10.47.100.109 vr VR-
Default
• A remote endpoint (AP) must be at least one hop away from the ExtremeXOS local endpoint.
The configuration must include at least one gateway router between the AP and the switch. The
gateway must enable IP MTU (Maximum Transmission Units) of 1550 bytes.
Example:
configure vlan VLAN_3000 add ports 48 tagged
configure vlan VLAN_3000 ipaddress 10.47.1.104 255.255.254.0
configure virtual-network local-endpoint ipaddress 10.47.1.104 vr "VR-Default“
configure vlan VLAN_3105 add ports 47 tagged
configure virtual-network "IDAP" vxlan vni 8192
configure virtual-network "IDAP" add vlan VLAN_3105
configure virtual-network IDAP add remote-endpoint vxlan ipaddress 10.47.100.100 vr VR-
Default
configure virtual-network IDAP add remote-endpoint vxlan ipaddress 10.47.100.108 vr VR-
Default
configure virtual-network IDAP add remote-endpoint vxlan ipaddress 10.47.100.109 vr VR-
Default
VLAN Groups
A VLAN group can be associated with a single wireless network. In a large venue, a VLAN group can
support many wireless clients on a single WLAN. The wireless client can associate with any VLAN in the
group. The association is determined by a MAC address hashing algorithm.
Note
Bridged@AC topologies using AP39xx access points are supported.
To access VLAN Groups, go to Configure > Policy > VLAN Groups.
• Select a group to view or edit.
• Select Add to add a new group.
Consider the following with VLAN Groups:
• Bridged@AP and Fabric Attach topologies are not supported.
• In the case of a VLAN ID conflict, the member VLAN ID takes precedence over the group VLAN ID.
Related Topics
VLAN Group Settings on page 278
VLAN Group Settings
To create a VLAN Group:
1. Go to Configure > Policy > VLAN Groups.
2. Click Add.
3. Configure the following parameters:
Name
Group name.
VLAN Groups
Configure
278 Extreme Campus Controller User Guide for version 5.46.03